Products

1/2" diameter tab on sale for 40% off for a limited time only! The Motobilt 4 link axle tabs are laser cut out of 3/8" thick steel plate. These brackets are built with pure strength in mind! We offer these brackets for just about every axle and link combination out...
The 78-79 Dana 60 truss from Motobilt will greatly increase the strength of your front axle. The main structure of this axle truss is laser cut and cnc bent from 3/8 inch thick steel plate. Supporting the main truss are 3/8 inch and 3/16 inch structural bracing. The top portion...
The Motobilt Bump Stop Pad is designed for 3” axel tubes.  The bump stop pad can easily be modified with slight grinding to fit larger diameter axle tubes if the DIY fabricator or professional installer needs to fit it. The bump stop pads are laser cut and CNC formed in...
Chevy full width Dana 60 Axle Truss System with integrated double ended steering ram mount. The Motobilt Chevy Dana 60 axle truss is laser cut and bent out of 3/8 inch high strength steel for the main structure. The truss spans the length of the axle, and is included in...
The Motobilt MB4040 is a single spring perch that was designed specifically for the Chevy Dana 60 front axle. The passenger side perch is cast into the housing and cannot be altered. The driver's side perch can be cut off and a new perch welded on. The Motobilt MB4040 wad...
The Motobilt Dana 60/70 HD steel diff cover has many features that separate it from others. The Dana 60 / 70 HD steel diff cover features a 3/8 inch thick laser cut steel ring that will keep the cover from pulling away from the housing when dragging over rocks. The...
Coilover mounting tab for Dana 60 front kingpin style axle housings. Mounting coilover shocks to a Dana 60 front kingpin style axle has a couple challenges and the Motobilt MB2006 tab answers them. The tab is contoured on the bottom edge (weld surface) to follow the axle tube and contour...
The Motobilt Dana 60 lower link mounts are cnc laser cut 3/8" thick steel plate. The mounts are designed to fit the Dana 60 axle housing tubes. They are offset to allow the rod end and to achieve maximum articulation. They are made with a 3/4 inch bolt hole. They can be...
If you can weld and want to build your own diff cover, purchase the Dana 60 DIY DIFF Cover. Motobilt DIY Diff Covers are the same as our fully-welded diff covers, but sold as a kit including the pre-formed pieces and hardware you will need to complete the DIY project yourself....
This handy drilling guide is used to mark the hole centers when converting the wheel stub bolt pattern on a Chevy Dana 60 front axle wheel hubs from 8 bolt on 6.5” to 8 bolt on 170mm bolt circle diameter. Simply place the drilling guide over the stock wheel studs,...
This handy drilling guide is used to mark the hole centers when converting the wheel stub bolt pattern on a Ford Super Duty front axle wheel hubs from 8 bolt on 170mm to 8 bolt on 6.5” bolt circle diameter. Simply place the drilling guide over the stock wheel studs,...
The Motobilt Ford Dana 60 early king pin axle truss is laser cut and bent out of 3/8 inch high strength steel for the main structure. This kit was designed specifically for the 1978 to 1979 Ford King Pin dana 60 found in 250/350's. The truss spans the length of...
Spinner