Product Description

Why would you want our Motobilt Full Length Replacement Bed for Jeep Gladiator?

If you want to run up to 43” diameter tires, decrease your departure angle, have built-in lockable storage compartments, have protected inset LED tail lights, have a heavy duty steel bumper with recovery points, reuse your factory park sensors, have heavy duty steel fender flares, have integrated rear lower corner armor, still be able to tow, have ample cargo space, easily bolt on tons of accessories, have your bed stronger than any other factory body panel AND be the coolest kid on the block, then this complete kit is for you!

Make your Gladiator that standout custom vehicle you’ve always dreamed of, while improving its off-road capability, durability & function.


• Complete Motobilt Full Length Bed Kit for Gladiator
• Two Sealed & Lockable Storage Compartments with hinged steel covers
• Tailgate Kit including latches, automotive grade lanyards, hinges and aluminum license plate trim bezel
• Tail Light Mount Kit with aluminum trim bezels
• Round LED pop in tail lights
• Resistors for factory non-LED tail lights
• 3/4” LED Side Marker Lights for those who need them
• Off-road Only License Plate Lights / Third Brake Light
• Relocation Parts for factory fuel filler neck
• Provisions for either Gas fuel fillers or Diesel fuel fillers with DEF fluid filler
• Bed Stiffeners
• Front Cargo Tie Down Points
• Backing Plate for front Motobilt logo cutout
• Rear Bumper with sensor provisions and backup camera mount
• Rear Bumper Frame Mounts
• Rear Fenders
• Block Off Plate for Gladiators not equipped with 120v bed plug
• Bolt-On Rear Lower Corner Armor
• All Hardware needed for assembly and install


• Bolt-on Installation (no welding required)
• Same length as factory bed
• Increased departure angle
• Heavy duty steel construction
• Fold down tailgate with automotive grade cables
• Rattle free adjustment latches with integrated rubber bumpers
• Two sealed & lockable storage compartments
• Recessed LED tail lights with reverse lights included
• Mount for rear facing accessory lights
• Recessed License Plate
• Rear Camera Mount
• Uses factory fuel filler neck and cap. No emissions concerns as the fuel system is not modified.
• Aluminum trim bezels around taillights and license plate for a custom look
• Rear Bed Stiffeners with tie down points
• Forward tie down points to secure your cargo
• Integrated Slots along top bed rail to bolt on accessories
• Larger wheel openings for large diameter tires
• Heavy duty bolt on fenders
• Heavy duty bolt on rear bumper
• Rear bumper integrates rear parking sensors
• Bolt on zip tie tabs to help arrange wiring
• Complete assembly / install instructions



No Products in the Cart