Plow Disk Wok For Outdoor Cooking

Plow Disk Wok For Outdoor Cooking

A local customer came in the shop with a few old plow disks and asked if I could make a wok for them. Converting a plow disk into a wok is not too difficult. We measured the hole in the center and cut a 1/4" thick steel circle on our CNC plasma cutter. Once the circle was cut we welded it in the center using our Miller Dynasty 200 DX TIG welder. Once welded in place we polished it down to make it smooth for easier cleaning and cooking. Next we designed some handles in Solidworks and also cut them on our CNC plasma table. Once the handles were cut out we tumbled them with heavy stone to give them more of a used look. Check out the finished product.


Leave a comment

Please note, comments must be approved before they are published


News


Related Posts

Prototyping the Motobilt Roll Cage for Jeep JKU - PART TWO
Prototyping the Motobilt Roll Cage for Jeep JKU - PART TWO
Read Part One here. The JKU roll cage was completely manufactured in a welding fixture that we designed and built in-...
Read More
Prototyping the Motobilt Roll Cage for Jeep JKU - PART ONE
Prototyping the Motobilt Roll Cage for Jeep JKU - PART ONE
We have built quite a few cages over the years for previous Motobilt projects & now the time has come to finalize...
Read More
Video - Motobilt Red JL Build Part 4 - Cages and Axles!
Video - Motobilt Red JL Build Part 4 - Cages and Axles!
Hurricane Sally put a slow down on things earlier this week, but the Motobilt team pushed through and kept everything...
Read More