MB1081

Frame Chop Rear Bumper and Cross member for Jeep JK / JKU

$659.00
Shipping calculated at checkout.

The Motobilt Jeep JK Rear Frame Chop Bumper allows for 5 inches of additional ground clearance over the factory receiver hitch. The additional ground clearance you gain is the same as going from a 35 inch tire to a 40 inch.

Fits:

Jeep JK & JKU Wrangler 2007 to 2018

Specifications

  • 3/16 inch Laser cut and CNC bent steel body
  • 3/4 inch Thick laser cut D-Rings that pass through the bumper and welded inside and out
  • Gain 2 3/8 inches up and 3 3/8 inches back of ground clearance
  • 5 inches of additional clearance over the factory receiver hitch
  • Ultra tight design allows the use of a large spare tire
  • Full protection from corner to corner
  • Includes high strength cross member
  • Cross member bolts into factory body mounts then must be welded to the frame
  • Works with factory frame or Motobilt jeep JK back half kit
  • Cross member includes pre-installed threaded inserts for mounting Motobilt JK frame chop rear bumper
  • Threaded mounting holes for JK rear fuel cell skid plate also included
  • Ships raw steel. Must be painted or powder coated to prevent rust.  See (Steel-It)

  • Installation video can be found under the Instructions tab
  • Includes necessary hardware
  • Weight: 80lbs (approx.)

Notes:

  • Requires cutting of rear frame rails and removal of factory rear cross member
  • Cross member must be welded to frame rails.
  • A receiver hit will NOT work with this bumper.

Product Components

Instructions

Installation Instructions