The Hammer Jeep JK Front Bumper NOW AVAILABLE

The Hammer Jeep JK Front Bumper NOW AVAILABLE

The brand new Motobilt Jeep JK front bumper has been dubbed "The Hammer". Our newest creation has provisions to mount the factory fog lights or aftermarket LED fog lights. We have pre-installed riv nuts for 10-24 screws in the factory bolt pattern. The Hammer bumper can be run with or without the optional skid plate as pictured. The ends of the Hammer bumper taper up for tire clearance. Each cut in the bumper was intentional to keep it tight to the frame rail for a better approach angle.


Leave a comment

Please note, comments must be approved before they are published


News


Related Posts

The next Motobilt build begins - Alex's Red Jeep JL
The next Motobilt build begins - Alex's Red Jeep JL
Well now that Charles Hansen's Tan TJ build is done, it is time for the Motobilt team to move on to the next build, w...
Read More
Motobilt Tan One Ton Jeep TJ Build is Going Home
Motobilt Tan One Ton Jeep TJ Build is Going Home
If you haven't already seen the build we did for Charles Hansen's tan Jeep TJ, go take a look now.  This build is ful...
Read More
Space Between your Jeep JL JT Cup Holders
Space Between your Jeep JL JT Cup Holders
Since the introduction of the Jeep JL I have seen so many posts on social media asking what the slot between the cup ...
Read More