Aluminum Front Fender Flares for Jeep JL/JLU/JT Gladiator

Shipping calculated at checkout.


Motobilt Front Fenders for Jeep JL 2 door and 4 door are the answer to flimsy factory plastic fenders. The Motobilt JL fenders are made from 3/16” laser cut aluminum providing a fender flare ready for the toughest trails on earth. The cutting edge design allows the fenders to fit perfectly and their raw finish means you can match them to your specific color needs. The Motobilt Front fenders for Jeep JL/JLU give you more clearance needed for larger tires providing protection and looks to set your Jeep JL apart from others. 

The Motobilt Front fenders for the Jeep JL are a bolt on design fitting both the 4 door and 2 door Jeep JL 2018-current. Keep in mind the JK was also manufactured in 2018 and the fenders will not fit the JK. The design of the front fender includes a small LED turn signal light.  The factory front fenders extend far out on the front corners of the Jeep often times making them prone to hit trees and other obstacles when off-roading. The Motobilt design tapers the fenders in as they go forward on the Jeep keeping them tighter to the Jeep. 

Included are a passenger and driver side front fender flare and all of the necessary mounting hardware for the front of your Jeep Wrangler JL 2 door or 4 door.

S hips bare aluminum, which is softer and more easily damaged than steel. If you are looking for ultimate protection and plan to wheel your rig, you should consider the steel fender version instead. These are meant for those who value weight savings over strength.  You can color match or sand for a custom look.

Suggested Inner Fenders:

MB1097Front Inner Fenders Aluminum for Jeep JL/JLU/JT Gladiator

MB1150Aluminum Blank Front Inner Fenders for Jeep JL/JLU/JT Gladiator

MB1243- High Clearance Front Inner Fenders for Jeep JL/JLU/JT for 40” + Tires



  • Includes driver and passenger side fenders
  • Includes Qty (2) LED turn signal lights
  • Includes mounting hardware
  • Includes Motobilt aluminum vent trim panels 
  • Made in house at Motobilt in the USA
  • Weight 13 lbs

 Product Components



  • The fender flares require drilling holes and trimming factory tabs on the front of the Jeep to install.  You will need to repaint the areas where you trim.

Installation Instructions