Compatible With:
JT
The rear of a Gladiator takes abuse on the trail, especially around the corners, departure angle, and recovery points. Factory bumpers offer limited protection and do not give builders much confidence when recovery or hard trail use becomes part of the equation. Many bumpers add weight and lose factory functionality in the process.
The Motobilt Hammer Rear Bumper was designed to solve that problem without forcing compromises. This bumper keeps critical factory systems in place while adding the strength, recovery points, and protection serious Gladiator builds need. It reuses factory wiring, retains the factory 4-7 pin trailer connector, works with the factory hitch, and accommodates factory rear park assist sensors using bolt-in sensor mounts designed to position them near stock locations.
Built from steel and reinforced where it matters, the Hammer rear bumper includes two fully welded 3/4-inch recovery mounts tied into the structure of the bumper, frame reinforcement brackets, and protection for the vulnerable Gladiator bed corners. The recessed step includes serrated edges for secure footing and the recessed license plate mount keeps the rear profile clean while maintaining practical function.
Like many Motobilt parts, this bumper was designed from a builder’s perspective. Clearance, recovery strength, wiring serviceability, and fitment were all considered. Integrated zip tie mounts help keep wiring organized, and if your Gladiator is not equipped with rear park sensors, blank-off plates are included to cleanly finish those openings.
This is a bolt-on bumper, but it is far more than a simple replacement. It is designed for builders who use their trucks, tow with them, wheel them, and expect armor to do more than just look the part.
Want To Know More?
Find all the information you need to get the right part for your rig.
Vehicle Fitment
2020-Present Jeep Gladiator JT
Material
Steel
Weight
72 lbs approx.
Recovery Points
Two 3/4-inch fully welded D-ring mounts
Sensor Compatibility
Factory rear park sensors retained
Trailer Wiring
Reuses factory 4-7 pin connector
Installation
Direct bolt-on
Finish
Ships bare steel
Manufactured
Made in the USA
Will this bumper work with the factory hitch?
Yes. The bumper is designed to work with the factory hitch, though a small portion of the hitch requires trimming for clearance.
What tag lights does this bumper use?
Reuse your factory Rubicon license plate lights (Please Note: "Sport" models may have different inner & outer license plate light bezels. This bumper is compatible with these Mopar light bezels: 6TC49RXFAA, 6TC51RXFAA, 6TC48RXFAA, 6TC50RXFAA) These may be discontinued from Mopar if so you are looking for Factory Rubicon rear bumper light bezels.
Can I keep my factory rear park sensors?
Yes. This bumper is designed to reuse factory rear park assist sensors using included bolt-in sensor mounts.
Does this bumper reuse factory trailer wiring?
Yes. The factory 4-7 pin trailer connector is retained, along with integrated provisions to secure wiring.
Does this bumper have recovery points built in?
Yes. It includes two fully welded 3/4-inch recovery D-ring mounts integrated into the bumper structure.
Does the bumper come coated?
No. It ships in raw steel and must be painted or powder coated before installation.
Motobilt offers industry leading, American-made off-road parts, focusing on quality and precision. Every product is built in-house, ensuring reliable performance for your adventures. Let us be your go-to source for industry leading, top-notch gear and support in your off-road journey.
Phone: 334-219-2333
Email: info@motobilt.com
© 2026 Motobilt, All rights reserved.
Your cart is currently empty.
Start Shopping
