The Motobilt Jeep JK Front the Hammer Bumper is a 48.5-inch wide, sleek, tight-fitting design proudly made in the USA. Our JK The Hammer Bumper is 3D CAD designed to ensure the best possible fit to your Jeep JK. The bumper will fit all year models of the Jeep JK 2 door and 4 door JK Unlimited. The front d-ring mounts are CNC cut from 3/4-inch-thick steel plate and pass through the bumper where they weld to the bumper mounting plates in addition to the bumper body. This was done for added strength to the recovery point.
The Hammer bumper has provisions to mount the factory fog lights or aftermarket LED fog lights. We have pre-installed riv nuts for 10-24 screws in the factory bolt pattern. The Hammer bumper can be run with or without the optional skid plate. To install the skid plate, you have to trim approx. 1 inch off each side of the crash bars. If you remove the skid plate later, the part that you trimmed will not be seen. The ends of the Hammer bumper taper up for tire clearance. Each cut in the bumper was intentional to keep it tight to the frame rail for a better approach angle. The main construction of the bumper is fabricated from 3/16-inch-thick high strength steel plate. The bumper also serves as a winch mount. The top side of the JK The Hammer Bumper has bolt holes for a recovery winch.
Fits:
Jeep Wrangler JK / JKU 2007-2018
Want To Know More?
Get the Details
Find all the information you need to get the right part for your rig.
Important Information
Winch: Our winch bumper is designed to fit a standard mounting pattern of 10" x 4.5" and has been tested with the Warn VR EVO and Zeon series winches. It may also fit other untested winches.
Sway Bar Compatibility: Works with all factory sway bars including Rubicon and works with Anti-Rock as well.
Ships raw steel. Must be painted or powder coated to prevent rust. See (Steel-It)
Product Specifications
Jeep JK The Hammer 48.5-inch front bumper with stinger
Fits all year models of the Jeep JK 2 door and 4 door JK Unlimited
Fabricated from 3/16-inch-thick high strength steel plate.
Bolt on design.
Pass through d-ring mounts weld to the bumper.
3/4-inch-thick steel d-ring mounts
Fog Light holes for factory fog lights.
Pre-installed riv nuts for 10-24 screws in the factory bolt pattern.
Proudly Made in the USA: Crafted with precision and pride in the United States, ensuring the highest quality and supporting American manufacturing.
Sold as each.
Weight: 80lbs (approx.)
Notes
If installing a winch, MB1002 or MB1141 fairlead mount will also need to purchase.
No cutting required on the frame rails on your Jeep JK
The two outside top bolt holes on your frame need to be drilled out to 9/16 inch.
