Crusher Series Front Bumper for Jeep JK / JKU

The Motobilt Jeep Wrangler JK Crusher recessed winch bumper will provide you the ultimate in protection and recovery. The bumper allows you to secure your winch down low in between the frame rails. The high clearance design includes a built in skid plate also. The bumper is made from 3/16 inch thick steel plate that is laser cut at Motobilt HQ then cnc bent. The bumper uses 3/4 inch thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out. This setup provides for superior strength.

Specifications

• Jeep Wrangler JK front Crusher bumper recessed winch bumper
• Measures in at just 46.5 inch at its widest point
• 3/16 inch thick steel plate
• 3/4 inch thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out
• Includes all the necessary mounting hardware
• Sold as each
• Weight: 70lbs (approx.)

Note:

• Will Not work with Teraflex S/T Dual rate front sway bar
• The outer edge of the crash bar will need to be trimmed to fit where the lower portion of the bumper mounts
• The 8 factory mounting holes may need to be open up to a 9/16".
• Ships bare metal and will need to be painted or powder coated
• 2012 and newer models will need a vacuum relocation pump PN MB2060.  The factory bracket must be cut off in order for the winch plate to fit.
  
• Previous versions of this bumper may ship with fairlead spacer.
• Does NOT work with Super Winch EXP

Product Components

Instructions

Installation Instructions